spacer 12
VJP title
Utamaro print showing

 

spacer 16
 

FAQ: How were crepe prints made?

 

chirimen detailChirimen-gami-e ("compressed thread paper prints") were crinkled paper prints or "crepe" prints (sometimes referred to as 'crepon'). Ukiyo-e crepe prints were produced at least as early as 1800 in Edo, and throughout the nineteenth century they were used on occasion for alternate states of some ukiyo-e designs. The compression technique resulted in a highly textured surface and noticeably smaller paper sizes, which offered a different aesthetic from the image printed in standard editions. Despite the extra effort involved in making these prints, they were, it seems, more a novelty than an attempt at serious refinement of the printed image.

There was a revival of chirimen-gami-e production in the 1880s with the advent of crepe-paper books to satisfy a growing Western market. Best known are those published by the Hasegawa company, which was opened in 1885. Their chirimen-gami publications were especially popular for children's books, as the crepe paper was somewhat resistant to tearing and thus had a better chance of surviving handling by children.

One method of making chirimen-gami has been documented (see the illustration below).

arrow Also see Detail of a chirimen-gami-e.

After the image and inscriptions were printed in the usual fashion, the dampened printed sheets were interleaved with cardboard molds (kata) that were incised with parallel grooves. The prints and molds were then wrapped together around a vertically mounted cylindrical wooden post roughly 3cm in diameter. This post had a fixed collar at the bottom to secure the wrapped sheets of paper. The upper part of the post had a loose collar that also held the papers and was moved downward by a wooden lever. At about 1/3 from one end of this lever there was a hole drilled wide enough so that the lever could move freely a short distance up and down. The lever was unattached at the end held by the person making the chirimen-gami but hinged at the end closest to the vertical post by a dowel run through the lever and mounted horizontally between two vertical supports.

Momodai illustration

By pressing the lever down an enormous amount of pressure could be exerted upon the papers and molds, thus compressing the papers and imparting a textured effect from the molds to the interleaved, dampened papers. Multiple pressings were applied after arranging the sheets slightly differently following each compression, and this was done 10 times or more to gain the desired crinkled and compressed effect (see enlarged textural detail, top right of this page). The process not only crinkled the papers but reduced their size significantly while still maintaining the proportions of the images and text in all dimensions. After the process of "creping" was completed, an untrimmed ôban print (ranging in size from approximately 360 x 240 to 385 x 360 mm) could measure as small as 260 x 190 mm. ©2000-2001 by John Fiorillo

BIBLIOGRAPHY

  • Frederic Scharf: Takejiro Hasegawa: Meiji Japan's Preeminent Publisher of Wood-block-Illustrated Crepe-Paper Books, Peabody Essex Museum, Salem, 1994, p. 12, fig. 5.

arrow Return to FAQ

spacer 16
 
     
 
 
Viewing Japanese Prints
Designed & Written by John Fiorillo
Site launched 1999
All texts and pictures are copyright © (All Rights Reserved)
and may not be reproduced without permission.